10 Inch rack with side and top panels – Remastered Design
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This design is inspired by the excellent work of @Mauker . I Created an enhanced version with additional features.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 35
- Makes
- 1
- Views
- 301
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
To print de basic structural you will need:
2 x 10-inch-rack-Foot
2 x 10-inch-rack-foot cross
4 x 10-inch-rack-Pilar
2 x 10-inch-rack-Pilar-middle
2 x 10-inch-rack-Top
2 x 10-inch-rack-Top-cross
1 x 10-inch-rack-Top cross -middle
The side panels uses magnets (9.5 mm diameter - 1.5/2 mm width) to be in place.
Top panels uses pressure fit.
The holes of the rack units from top and bottom are short and will screw into plastic (M5 - 10/12 mm lenght)
You will need to asemble the basic structure:
36 x M5 10mm bronce inserts.
12 x M5 20mm screws
6 x M5 25mm screws
6 x M5 30mm screws
For each module M5 25MM screws and nuts.
The magnets I used for the side panels were 9.5 mm and 1.5 mm width. You can use something similar up to 10 mm and 2 mm width.