Extended Throw Lever for AGM Rattler V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an extended throw lever that slips over the focus ring of an AGM Rattler V2 thermal riflescope.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 200
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Open Community License v1
I made this to extend the focus ring throw lever for my AGM Rattler V2 thermal scope. Especially when it's mounted on the rifle in the dark, I found it very hard to adjust the focus ring. With this extended throw lever, it is much easier to adjust it by feel without having to move my head.
Confirmed Fit:
Rattler V2 19-256
Rattler V2 25-384
Rattler V2 25-320
Rattler V2 25-256
To install:
Use a non-marring plastic pry tool to help separate the spring-loaded lens cap from the end of the scope. It will snap off. Set it aside.
Take careful note of which orientation you want to install the extended throw in. The focus ring only moves about 60 degrees. I chose to have mine face vertically upwards, so it will be easy to feel for in the dark.
Slowly press the extended throw lever over the focus ring. It is a very tight fit, and you will likely need to shimmy it down. You shouldn't need to use a hammer, though. Just your fingers is fine.
Snap the lens cap back in place.
Please Note:
It's a very tight fit! If you absolutely cannot fit the part onto your focus ring, you might need to adjust the size in the slicer or modify the CAD until it feels like a good fit. In your slicer, try multiplying the size by an additional 2% in all dimensions and try again.
I printed the part in PETG. With most 3D printable filaments, the part will loosen its grip over time.
I recommend 4 perimeters to basically print the part solid. You want perimeters, not infill.
Be careful when installing.
My scope is the Rattler V2 25-384. Other versions of the Rattler might not fit. I don't have those dimensions to check. Any 19 or 25mm lens version should use the same focus ring and work fine, though. From product photos, the Rattler V3 also looks like it would fit. If you try out this part for a different Rattler than the V2-25-384, please leave a comment so I can update the compatibility list. Thank you to those who have messaged me to confirm a good fit on their scope!
Selling this would violate AGM's policies (whether you agree with them or not is up to you), but I'm making the design free for anyone to download. If you really want one but you don't have access to a 3D printer, please send me a message and I would love to help you get this lever in your life. It really has made mine easier :)