Zato Hi Hat Clip Drum Stick Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This can be attached to a hi hat stand in order to hold drum sticks.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 126
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Introducing the Zato Hi Hat Drum Stick Holder!
Two versions are included, with or without magnets.
Required Hardware
M4-.70 x 10 Machine Screws. I prefer the look of hex drive/allen drive cap screws, but regular phillips works as well.
M4-.70 Hex Nuts OR Wing Nuts. Wing nuts are easier to use, hex nuts look better.
Magnet Version
6x2mm Magnets
Printing Instructions
I don't have any exact printing instructions, but I have printed in PETG and PLA with 4 walls and 40% Gyroid infill with success. Depending on your setup, you may want to use tree supports so the screw holes and magnet holes are roundish.
IMPORTANT I printed the clips on their side (screw holes going horizontally)
Compatibility Note
This works for my hi hat, but it may not work for yours. Minor scaling adjustments should be fine for the non-magnet version, without losing the ability to use the screws, but if the changes are too major, you may have to buy smaller screws.