1 / 2
Zato Hi Hat Clip Drum Stick Holder — image 1
1 / 2

Zato Hi Hat Clip Drum Stick Holder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This can be attached to a hi hat stand in order to hold drum sticks.

Rating
0 / 5
Likes
5
Downloads
26
Makes
0
Views
128
Reviews
0

Updated at source:

Model information

Category
Music
License
Creative Commons — Attribution — Noncommercial — Share Alike

Introducing the Zato Hi Hat Drum Stick Holder!

Two versions are included, with or without magnets.

Required Hardware

  • M4-.70 x 10 Machine Screws. I prefer the look of hex drive/allen drive cap screws, but regular phillips works as well.

  • M4-.70 Hex Nuts OR Wing Nuts. Wing nuts are easier to use, hex nuts look better.

Magnet Version

  • 6x2mm Magnets

Printing Instructions

I don't have any exact printing instructions, but I have printed in PETG and PLA with 4 walls and 40% Gyroid infill with success. Depending on your setup, you may want to use tree supports so the screw holes and magnet holes are roundish. 

IMPORTANT I printed the clips on their side (screw holes going horizontally)

Compatibility Note

This works for my hi hat, but it may not work for yours. Minor scaling adjustments should be fine for the non-magnet version, without losing the ability to use the screws, but if the changes are too major, you may have to buy smaller screws.

Tags