Prusa XL Enclosure TPU holder (bracket+spool holder)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to enable direct feeding of TPU durning a print on Prusa XL with an enclosure.
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 65
- Wydruki
- 3
- Wyświetlenia
- 355
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I designed a bracket(mount) + filament spool holder that fits onto existing holes of Prusa XL enclosure. This allows/enables direct feeding of the TPU filament into extuder, thus bypassing long feed route through PTFE tubes. I did not find any online yet, so enjoy :-).
You will need three screws (I have recycled what was a leftover from original prusa XL box after I assembled it.
Screw it onto the right side, if you mirror it, it is possible to use left side as well (I have buddycam there). As for the Spool holder, just simply slide it into the mount and remove after you are done, to avoid colision with the door.
I definetly suggest to use PETG. Print without supports with at least 15% infill (I tested 15 and 25% gyroid)
PS. The mount model is also ready to utilize original spool holder packaged in the box, but It has to be mounted with a screw & nut and disassembled after (door collision)