PermaTag – Tamper-Proof AirTag Case Sealed During Print (No Screws)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
PermaTag is a permanently sealed AirTag enclosure. Insert during print. Seal forever.
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 29
- Wydruki
- 1
- Wyświetlenia
- 180
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
⚠ Step 0: Replace the Battery. Seriously.
Before printing this case:
Open your AirTag.
Replace the CR2032 battery.
Close it.
Because once you seal it inside this case…
there’s no going back.
Battery dies = case dies.
Simple as that.
You’ve been warned 😄
What is this?
This is not your typical AirTag case.
No screws.
No clips.
No snap-fits.
This design gets permanently sealed during the 3D printing process.
You pause the print, insert the AirTag, resume printing — and the top layers close it forever.
Once finished, the AirTag cannot be removed without destroying the case.
Why this design?
Because sometimes you don’t want accessibility.
You want permanence.
Anti-tamper solution
One-piece body
No mechanical opening system
Ideal for hidden or semi-permanent installations
Impossible to open without breaking it
Sealed design improves resistance to water and dust
Perfect for:
Bicycles
Vehicles
Tools
Equipment
Asset tracking
Hidden installations
Printing Instructions
Recommended materials: PETG / ASA
Print orientation: as provided
Perimeters: 4
Top/Bottom Layers: 5/6
Infill: 50%
Pause at layer: 52 @0.2mm layer
No supports required
Battery Replacement
PermaTag is a permanent enclosure.
To replace the battery, the case must be physically broken open.