1 / 5
Reinforced 2 inch Desk Cable Grommet for Hollow-Core Doors with 36mm Pass-Through Hole — zdjęcie 1
1 / 5

Reinforced 2 inch Desk Cable Grommet for Hollow-Core Doors with 36mm Pass-Through Hole

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Reinforced 2 inch cable grommet that protects hollow-core desks with compression clamping design. 36mm Pass-through hole

Ocena
5 / 5
Polubienia
3
Pobrania
21
Wydruki
1
Wyświetlenia
157
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Office
Licencja
Creative Commons — Attribution

This is a reinforced compression cable grommet designed specifically for hollow-core desk surfaces such as door slab desktops. Unlike decorative grommets that rely on thin veneer for support, this system clamps the top and bottom skins together and reinforces the internal gap, preventing crushing, delamination, and long-term wear.

Once installed, the cutout behaves like a structural bulkhead. The hole becomes stronger than the surrounding panel and resists creep from repeated cable movement.

Designed for a 2 inch (50 mm) opening with a 36 mm cable pass-through, large enough for bundled cables, HDMI heads, and power leads.


Files Included

  • Top Grommet Flange.stl (threaded top piece)

  • Bottom Compression Ring.stl

  • Gap Support Segment.stl (print 8x)

The Top Grommet Flange and Bottom Compression Ring form a threaded clamp. The Gap Support Segments reinforce the internal cavity of hollow-core panels.


Installation

Requires a 2" hole saw.

  1. Drill a clean hole through the surface

  2. (Optional - Removable) Wick glue into exposed core and allow to cure

  3. Insert 8 Gap Support Segments into the internal cavity arranged similar to rendered image

  4. (Optional - Semi-Permanent) Wick glue into exposed core and supports then secure before curing

  5. Install the Top Grommet Flange from above

  6. Thread on the Bottom Compression Ring and tighten until snug

Glue is recommended for maximum durability but not strictly required.

Tip:
Glue the gap support segments into pairs before installation. Join two pieces bottom-to-bottom so the retaining tabs point outward at each end. This lets you insert them as quarter sections instead of individual pieces, which makes placement much easier and prevents segments from slipping into the hollow cavity while you position them.


Gap Support System

The Gap Support Segments are designed for printability and easy insertion. They are sized for a 28 mm (~1.125") internal gap and include a raised retention feature to prevent inward slip. If needed, the raised tabs are thin enough to trim with a knife for custom thickness panels.

These supports distribute compression evenly and prevent internal collapse.


Why this design exists

Standard desk grommets eventually crush hollow-core panels. This design:

  • clamps both skins together

  • reinforces the internal gap

  • spreads compression load

  • prevents veneer failure

  • resists long-term creep

Ideal for door desks, lightweight furniture, and sandwich panel construction.

Tagi