SHH Newt Shifter Mount V3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A dovetailed 4080 mount for the SHH Newt sim racing shifter. I have a sequential shifter that uses this mount.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A dovetailed 4080 mount for the SHH Newt sim racing shifter which allows it to be quickly swapped out for my DIY 3D printed sequential shifter.
Printed with PLA, 4 walls, 15% infill. The shoulders of the 4080 mounting holes are printed solid so I could bear down on the screws without crushing the part. I included the modifier used to make them solid. While you can do it manually in the slicer, it's much easier to create the modifier in CAD.
The plate looks a bit rough as I had a little over extrusion in that print. Just two quick passes over a sheet of medium grit sandpaper to knock down the high spots. I was too lazy to hit it with the heat gun to make it pretty again. Never going to see it except when swapping shifters.
I use this same mount for my sequential shifter.