1 / 2
Xtool F2 Ultra UV K5 80mm Ornament Jig — zdjęcie 1
1 / 2

Xtool F2 Ultra UV K5 80mm Ornament Jig

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

80mm round K5 crystal ornament jig for the Xtool F2 Ultra UV

Ocena
0 / 5
Polubienia
5
Pobrania
63
Wydruki
0
Wyświetlenia
297
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This jig is made for the Xtool F2 Ultra UV. Specifically for the 80mm K5 crystal ornament purchased through Xtool but any of that size should work. The purpose is to allow for subsurface engraving because subsurface K5 engraving requires elevating over the bed and defocusing by -4mm. Unlike with K9 crystal, K5 does NOT use the inner engraving platform or lens. This can also be used for surface engraving for easier center alignment. 

 

This is stated by Xtool - Important Notes: When processing, apply masking tape to the glass surface for focusing. After the focus is complete, remove the masking tape and then engrave. During processing, set the focal point to sink 4mm to enable engraving into the interior of the glass.

Tagi