1 / 2
Xtool F2 Ultra UV K5 80mm Ornament Jig — image 1
1 / 2

Xtool F2 Ultra UV K5 80mm Ornament Jig

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

80mm round K5 crystal ornament jig for the Xtool F2 Ultra UV

Rating
0 / 5
Likes
5
Downloads
63
Makes
0
Views
297
Reviews
0

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial — Share Alike

This jig is made for the Xtool F2 Ultra UV. Specifically for the 80mm K5 crystal ornament purchased through Xtool but any of that size should work. The purpose is to allow for subsurface engraving because subsurface K5 engraving requires elevating over the bed and defocusing by -4mm. Unlike with K9 crystal, K5 does NOT use the inner engraving platform or lens. This can also be used for surface engraving for easier center alignment. 

 

This is stated by Xtool - Important Notes: When processing, apply masking tape to the glass surface for focusing. After the focus is complete, remove the masking tape and then engrave. During processing, set the focal point to sink 4mm to enable engraving into the interior of the glass.

Tags