1 / 4
Minisforum 10" rack mount MS-01 MS-A1 MS-A2 MS-R1 — zdjęcie 1
1 / 4

Minisforum 10" rack mount MS-01 MS-A1 MS-A2 MS-R1

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

10 inch 1U rackmount for Minisforum MS-01 / MS-A1 / MS-A2 / MS-R1

Ocena
4 / 5
Polubienia
18
Pobrania
164
Wydruki
1
Wyświetlenia
1848
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Share Alike

This is a different approach to rack mounting Minisforum MS series. Instead of holding the original casing, it replaces it, allowing 1U mount* for the machine

Also features 2x keystone jacks and ears for a cable clip and a flush button pusher.

FreeCAD source files are provided for your convenience.

Limitations

  • The device itself is a bit thicker than 1U. While I did my best to make it fit, the very rear part is still thicker.

  • The device must have bottom vents free to cool SSDs, and preferable top vents too

  • Because of that both, you can't mount multiple MS units directly stacked on top of each other; but it'll work fine if you interleave them with short 1U modules

  • The top/bottom covers are only for IP20 ingress protection; they provide no EMI shielding. Use it in an enclosed rack or deal with EMI yourself.

  • Because of space constrains it'll only fit smaller keystone modules.

  • Tested on MS-01 and MS-A1 but I see no reason it won't work on MS-A2, MS-R1 and similar future models.

Printing instructions

Main body

You need well calibrated printer with at least 220x220mm build plate to print this. Best printed in PETG – it'll keep the dimensional accuracy but won't melt like PLA if the device overheats.

Main model features solid front panel designed for slicer-made vents – beautiful, fast and sophisticated. 

To get them, set Perimeters to 5, set Gyroid / Hex / other neat infill pattern; then add a Modifier Cube to your build plate, roughly align it with front panel vents, then set modifications to: 

  • Top layers: 0 / 0mm

  • Bottom layers: 0 / 0 mm

Preview your results in sliced view.

If you don't like slicer-generated vents (or watched too many Slant 3D videos), use the alt model with pre-made vents. They aren't as cute though.

Button pusher

Print it in something bright / translucent. If the button, when lit, is not bright enough, make it hollow:

  • Perimeters: 1

  • Top layers: 1 / 0mm

  • Bottom layers: 1 / 0 mm

Tagi