1 / 2
LDO Nitehawk-36 (NH36) Toolboard WW-BMG for A4T toolhead mount — zdjęcie 1
1 / 2

LDO Nitehawk-36 (NH36) Toolboard WW-BMG for A4T toolhead mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Mount for installing a LDO Nitehawk-36 (NH36) toolhead board on an A4T toolhead using an WW-BMG extruder. Including bott

Ocena
0 / 5
Polubienia
4
Pobrania
26
Wydruki
0
Wyświetlenia
182
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

LDO Nitehawk-36 (NH36) Toolboard WW-BMG for A4T toolhead mount

Mount for installing a LDO Nitehawk-36 (NH36) toolhead board on an A4T toolhead using an WW-BMG extruder. Including bottom mounting slot for Xol-carriage.

https://docs.ldomotors.com/en/Toolboard/nitehawk-36

Features:

  • Designed specifically for A4T toolhead + WW-BMG combo.

  • Mounting pattern adapted for WW-BMG.

  • Keeps board connectors accessible for easier wiring and maintenance.

  • Uses the same toolhead mounting points/orbiter screw locations (no special hardware on the toolhead side required).

  • Geometry adjusted to clear the Orbiter body, cabling and typical cable chain routing.

Printing recommendations:

  • Material: ABS / ASA / PC(-CF) or similar heat‑resistant filament (recommended for higher temperatures around the toolhead).

  • Layer height: ~0.2 mm

  • Walls / infill: 3–4 perimeters, ~30–40% infill

  • Orientation: Print flat on the back side, no supports needed if oriented correctly.