LDO Nitehawk-36 (NH36) Toolboard WW-BMG for A4T toolhead mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mount for installing a LDO Nitehawk-36 (NH36) toolhead board on an A4T toolhead using an WW-BMG extruder. Including bott
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 26
- Makes
- 0
- Views
- 182
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
LDO Nitehawk-36 (NH36) Toolboard WW-BMG for A4T toolhead mount
Mount for installing a LDO Nitehawk-36 (NH36) toolhead board on an A4T toolhead using an WW-BMG extruder. Including bottom mounting slot for Xol-carriage.
https://docs.ldomotors.com/en/Toolboard/nitehawk-36
Features:
Designed specifically for A4T toolhead + WW-BMG combo.
Mounting pattern adapted for WW-BMG.
Keeps board connectors accessible for easier wiring and maintenance.
Uses the same toolhead mounting points/orbiter screw locations (no special hardware on the toolhead side required).
Geometry adjusted to clear the Orbiter body, cabling and typical cable chain routing.
Printing recommendations:
Material: ABS / ASA / PC(-CF) or similar heat‑resistant filament (recommended for higher temperatures around the toolhead).
Layer height: ~0.2 mm
Walls / infill: 3–4 perimeters, ~30–40% infill
Orientation: Print flat on the back side, no supports needed if oriented correctly.
