1 / 2
Increased gear ratio of Crank for Generator — zdjęcie 1
1 / 2

Increased gear ratio of Crank for Generator

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Experimenting with changing the shaft gear from 12 teeth to 10 teeth. This increases the output RPM.

Ocena
0 / 5
Polubienia
5
Pobrania
26
Wydruki
0
Wyświetlenia
328
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution — Noncommercial

I used Fusion 360 to remodel the shaft and crank from the original model such that I can adjust the gear ration.
I did not know the gear settings used in the original model so I set my own.
The files provided are drop in replacements for the original hand crank generator housing. 

This works well for my build , increasing the output voltage. With this upgrade I can get up to 23V open circuit. With a 2-3 Ohm load, I can get up to 14W - but can't sustain long by hand cranking.


Note: this was my first time I have designed a gear train. I have provided the parameters so that you can improve.