Increased gear ratio of Crank for Generator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Experimenting with changing the shaft gear from 12 teeth to 10 teeth. This increases the output RPM.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 26
- Makes
- 0
- Views
- 328
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Engineering
- License
- Creative Commons — Attribution — Noncommercial
I used Fusion 360 to remodel the shaft and crank from the original model such that I can adjust the gear ration.
I did not know the gear settings used in the original model so I set my own.
The files provided are drop in replacements for the original hand crank generator housing.
This works well for my build , increasing the output voltage. With this upgrade I can get up to 23V open circuit. With a 2-3 Ohm load, I can get up to 14W - but can't sustain long by hand cranking.
Note: this was my first time I have designed a gear train. I have provided the parameters so that you can improve.
