1 / 11
Extended Remix of N8thin's X-Shot MPP Stock-ish Stock — zdjęcie 1
1 / 11

Extended Remix of N8thin's X-Shot MPP Stock-ish Stock

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of N8thin's X-Shot MPP Stock-ish Stock that lengthens the stock by roughly 2.75 inches.

Ocena
5 / 5
Polubienia
33
Pobrania
77
Wydruki
1
Wyświetlenia
562
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Hello everyone! This is my remix of N8thin's beautiful X-shot MPP Stock-ish Stock model. I loved the stylings and feel of their stock, but I wanted a version that was a little bit longer to fit me better. So, that's what I set out to create, and here are the results! 

In the end, I lengthened the stock by about 2.75 inches, which I found to personally be the most comfortable.  I changed how the entire stock is printed and assembled, electing to split the body near the screw as opposed to splitting it lengthways, as well as choosing to use screws over glue. 

This remix requires three M3 X 10mm screws to be assembled: two going in through the top front, and one going in in the middle interior of the rear body piece. 

Rather than have the stock battery held inside the butt plate, I designed a pocket for it to be held more centrally in the body of the stock.  A side effect of this is that the snap-in rear detail piece must be removed before the battery can be placed/removed. 

All of the parts can be printed with minimal or zero support material in the orientations shown below:

Thank you so much to N8thin for sharing their beautiful stock, and especially for making the STEP files for the stock available to everyone! I had a ton of fun remixing this stock, and I hope everyone enjoys it as much as I am! 

Tagi