IKEA PAX belt hanger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds 2 belts for IKEA pax frame
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- GNU General Public License v3.0
I remixed SirOwl's design to make belts hang outside the frame
had to split the pins from the main part given that this is the only way to install it. Also boosted the hook back because the original brakes easily. This won't be going anywhere.
Print upside down with tree support only for the tip of the hanger as shown in the picture (use support block on the holes and any other parts)
print the pins laying flat without supports
mirror the part if you need it to be right side hanged
hammer in the pins after you choose the right height holes for you.
If you want to remove the pin for any reason screw a small screw into the pin and pull it out.
Printing parameters (experiment as you like) this just seamed to me the best longevity vs cost ratio.
Material: PTEG, I assume any material would work
20% infill
3 Wall layers
2 bottom, 3 top
I enabled ironing for a better finish
NO brim required