Shop Vacuum Cyclone Dust Collector v1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cyclone dust collector intended to attach to the top of a 5-gallon bucket to extend life of vacuum bags and filter.
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 63
- Wydruki
- 0
- Wyświetlenia
- 507
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial
Cyclone separator designed to be attached to the lid of a 5-gallon bucket. This is V1 of the design with several components. There is a small spiral in the wall of the cyclone to encourage spinning.
All made with PLA as I don't expect this to be mechanically stressed.
Components:
Cyclone separator: designed to fit the Core One+. Also designed for minimal supports when placed on top face down.
Anchor Ring: mating ring to anchor the cyclone from the inside face of the lid.
Cone washers: rough attempt at trying to improve bolt mating surface with the chamfered holes on the cyclone
Nozzle adapters: since every vacuum is different these are custom designed to fit my available hoses. Modify the attached models to fit your vacuum, but already have the mating setup.
Assembly considerations:
1.5 inch 1/4-20 bolts are needed.
Nozzle adapters were epoxied to the cyclone to create a strong bond and seal
Foam faster was added to the cyclone to provide a good seal around the bucket lid. Compressed using anchor ring