Shop Vacuum Cyclone Dust Collector v1
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cyclone dust collector intended to attach to the top of a 5-gallon bucket to extend life of vacuum bags and filter.
- Rating
- 0 / 5
- Likes
- 18
- Downloads
- 63
- Makes
- 0
- Views
- 507
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Creative Commons — Attribution — Noncommercial
Cyclone separator designed to be attached to the lid of a 5-gallon bucket. This is V1 of the design with several components. There is a small spiral in the wall of the cyclone to encourage spinning.
All made with PLA as I don't expect this to be mechanically stressed.
Components:
Cyclone separator: designed to fit the Core One+. Also designed for minimal supports when placed on top face down.
Anchor Ring: mating ring to anchor the cyclone from the inside face of the lid.
Cone washers: rough attempt at trying to improve bolt mating surface with the chamfered holes on the cyclone
Nozzle adapters: since every vacuum is different these are custom designed to fit my available hoses. Modify the attached models to fit your vacuum, but already have the mating setup.
Assembly considerations:
1.5 inch 1/4-20 bolts are needed.
Nozzle adapters were epoxied to the cyclone to create a strong bond and seal
Foam faster was added to the cyclone to provide a good seal around the bucket lid. Compressed using anchor ring