Photon S Z-stop spacer for Sovol FBS
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adjuster to increase your z-stop height when using Sovol magnetic flexible build plate.
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 284
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
This 2.2mm thick print is to be installed between your z-stop probe and the z-carriage on a Photon S when using a Sovol flexible build system. The Sovol instructions say that it will add about 2.6mm in height to the build plate, but I found (after trying multiple heights) that 2.2mm works best for my printer.
The good news is if you need a thicker z-stop spacer you can just change the height of this print in your slicer. I also replaced my screws with M3x8 to make sure there was a solid connection with the z-carriage.
I printed at 0.1mm layer height for accuracy with PETG on a Prusa MK3S+.