Riser For Nespresso Vertuo Pop+ & Extra Large Spent Pod Container
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raises a Nespresso Vertuo Pop+ coffee brewing machine 38mm, add 2-3mm depending on rubber feet that are used.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 210
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you have a Nespresso Vertuo Pop+ and the cup holder is obstructed, this model will raise the machine up 38mm. Rubber feet are recommended to prevent the stand from moving around. This variety pack comes in handy for projects like this - https://www.amazon.com/dp/B074C2XKXH?th=1
The stand is printed as 4 separate pieces that snap together. CA glue isn't needed but is recommended. The stand is mostly hollow so it won't use up too much filament.
The model in the pictures was printed with 15% infill, 4 wall loops, 5 layers for both top and bottom shells, no supports needed.
There's also an extra large spent pod container/catcher that can be used in conjunction with the stand. The internal factory spent pod container isn't very big and you often don't realize it's full until the pods back up or get crushed when you try to close the lid. The external container holds a lot more pods and you can see how full it is without having to take the cover off. In order to use the larger pod container you'll have to print the "Drip Tray" file that goes inside the brewer and fits together with the pod container. The container will need supports for the section that goes inside the nespresso brewer.
If you're interested in using the larger pod container without the riser check out this model -