Sunlu Filament Dryer Lid Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Snap on bracket to hold your filament dryer lid open at a 90 degree upright position
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Snap on bracket to hold your filament dryer lid open at a 90° upright position.
Made this to fit my Sunlu & Jayo FilaDryerS1 units. I've added a M10 PTFE fitting with a flange (https://www.printables.com/model/495572-m10-flange) on the back and needed something to keep my lid from folding all the way back and creasing my filament feed.
(Will probably fit many other dryers with similar lids. 5.5mm width for 3.7mm diameter pin hinge)
Easily snaps on the lid hinge in the open space.
Printed on AnkerMake M5 with Overture Matte PLA.
Layer Height: 0.2mm
Walls: 5 wall loops
Infill: 10% Aligned Rectilinear
Skirt Loops: 3
Size: X:55.00 Y:59.95 Z:5.50
Approximately 7.25g of PLA used per bracket. (Flat print with no supports needed.)
I used two brackets per dryer for more stability, but works well with just one bracket.