Simple Resizable Monitor Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Monitor Stand easy to print and assemble
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 50
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a stand that would fit the IKEA Lanespelare Monitor Stand.
The width depends on the base of my monitor, the depth depends on the Lanespelare and its distance from the wall, and the height depends on my desk.
The goal was to consume little filament and print quickly, as well as trying to fit the joints with the right offset (in my case, I left 0.10 mm).
Dimensions are: depth 180mm, width 200mm, height 72mm (see images).
Total depth 180mm, can be changed in Tinkercad or similar by rebuilding a new, longer vertical beam. Do not scale.
Total height (72mm), can be changed in Tinkercad or equivalent by rebuilding a new longer foot, Do not scale.
Total depth (180mm), can be changed in Tinkercad or equivalent by rebuilding a new, longer vertical beam, Do not scale.
I did a load test and the support held at least 12 kg distributing the load evenly (see image)
Since the feet are asymmetrical I prepared stl with numbers so as to orient them easily for both the feet and the supports.
There is a gap between the IKEA stand and the wall and the stand could fall into it, so I designed two rear legs that act as a spacer and cable pass-through for the monitor (see image)
I printed everything with 3 walls. No supports are needed. The print orientation for the "normal" feet is as shown in the image. The feet with the cable guide should be printed vertically. Infill 15%.
Have fun