Roof Rack fully printed for Prusa Core One L and Core One
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Roof rack to allow things to be placed on the printer without putting stress on the glass. (Core One not tested yet)
- Ocena
- 4,5 / 5
- Polubienia
- 25
- Pobrania
- 50
- Wydruki
- 1
- Wyświetlenia
- 479
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Open Community License v1
Print two identical copies.
Having some ABS spools tucked away in a cupboard, I used this material, but also to test my Corel One L.
I haven't tested it with other materials, but ASA and PETG, or even PLA+, should work.
For the ABS, I used an 8mm brim with zero spacing. Five perimeters with 20% infill. A 0.4mm nozzle with a 0.28mm DRAFT layer height.
Once the parts have cooled and been de-burred, place one of the parts flat and flip the second one 180 degrees over it so they fit together (see picture). The best way is to take a small piece of wood, place it on top of the top part, and gently tap it with a hammer, changing the position of the hammer with each tap.
If you wish, you can secure the two parts together using two or four M3x28mm screws and their corresponding nuts and washers. You can even glue them.
To attach this roof bar, place it on top of the printer enclosure on its tabs as shown in the photos, and press gently until you hear a click.
The dryer visible in the photos weighs between 5 and 9 kg depending on how much it's being used, and there is just a very little flex compared with the aluminum profile version.
⚠ You will also find a model for the PRUSA CORE ONE, but I didn't tested it, as I don't have A CORE ONE or CORE ONE PLUS. If anyone tries this, please comment. ⚠
⚠WARNING⚠:
This mod is not designed to support heavy loads, just like the Prusa Core One L's chassis.
It's use is entirely at your own risk.
If you place a filament dryer on it, have a look at: