Narwhal Squishy Mold!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Everyone's favorite Unicorn of the Sea, but squishy
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 171
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution — Share Alike
This is a Squishy mold kit of a classic Narwhal. The mold is a split mold that can be held together with 2 binder clips and a little scotch tape. I notched the mold out to reduce material, as well.
I recommend using Elmer's squishy mix, but any silicone casting resin will work just as well. The resin takes about an hour to set.
For best finish, I recommend painting on surface texture across the surface of the narwhal in the mold. Use a finer setting to hide the layer lines. .2mm layer height works fine, and the details turn out visible.
Scale up or down to your liking. A scale of about 150-165% will use the full 2-part Elmer's mix.
While the original model this was derived from was AI created, this mold model was not.