Narwhal Squishy Mold!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Everyone's favorite Unicorn of the Sea, but squishy
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 15
- Makes
- 0
- Views
- 171
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Sculptures
- License
- Creative Commons — Attribution — Share Alike
This is a Squishy mold kit of a classic Narwhal. The mold is a split mold that can be held together with 2 binder clips and a little scotch tape. I notched the mold out to reduce material, as well.
I recommend using Elmer's squishy mix, but any silicone casting resin will work just as well. The resin takes about an hour to set.
For best finish, I recommend painting on surface texture across the surface of the narwhal in the mold. Use a finer setting to hide the layer lines. .2mm layer height works fine, and the details turn out visible.
Scale up or down to your liking. A scale of about 150-165% will use the full 2-part Elmer's mix.
While the original model this was derived from was AI created, this mold model was not.