1 / 2
Nielsen Sonic 45 Schalldämpfer Reinigungsset Walnut Blaster Ultrasonic Ultraschall Wallnusschalenstrahlen — zdjęcie 1
1 / 2

Nielsen Sonic 45 Schalldämpfer Reinigungsset Walnut Blaster Ultrasonic Ultraschall Wallnusschalenstrahlen

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

zur Reinigung für den Modularen Nielsen Sonic 45 Schalldämpfer

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
83
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Mit der Reinigungshilfe kann ein Wallnusstrahlgerät (z.B. Autool HTS558) genutzt werden, um den Schalldämpfer gründlich zu reinigen. Sowie im Anschluss in einem Ultraschallbad zu waschen.

  • Düse oben, konisches Design um alle Bereiche zu erreichen

  • Sauger unten

  • Modul des SD in die Mitte (beidseitig nutzbar) 

  • Rillen in der Seite um einen Luftstorm zugewährleisten und Strahlgut zu entfernen

Zum Entfernen von Pulverrückständen und Verkokungen in den Modulen des Schalldämpfers

Funktioniert mit: 

  • Modul normal

  • Abschlussmodul Front

  • Abschlussmodul Mitte

  • Doppelmodul "Verbinder"

Einzelne Module im Anschluss in je einen Modulhalter klemmen für ein Ultraschallbad 

PLA 50% ist ausreichend

Set 1: Module

Set 2: Schalldämpferkörper (Gewinde)

Ausschließlich sauberes Wallnusstrahlgut verwenden 0,4mm!

With the cleaning aid, a walnut blasting device (e.g., Autool HTS558) can be used to thoroughly clean the silencer. Then wash in an ultrasonic bath.

  • Nozzle at the top, conical design to reach all areas

  • Suction cup at the bottom

  • SD module in the middle (can be used on both sides)

  • Grooves on the side to ensure air flow and remove blasting material

For removing powder residues and coking in the modules of the silencer

Works with:

  • Normal module

  • Front end module

  • Center end module

  • Double “connector” module

Clamp individual modules into a module holder for an ultrasonic bath

PLA 50% is sufficient

Use only clean walnut blasting material 0.4 mm!