1 / 2
Nielsen Sonic 45 Schalldämpfer Reinigungsset Walnut Blaster Ultrasonic Ultraschall Wallnusschalenstrahlen — image 1
1 / 2

Nielsen Sonic 45 Schalldämpfer Reinigungsset Walnut Blaster Ultrasonic Ultraschall Wallnusschalenstrahlen

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

zur Reinigung für den Modularen Nielsen Sonic 45 Schalldämpfer

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
83
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

Mit der Reinigungshilfe kann ein Wallnusstrahlgerät (z.B. Autool HTS558) genutzt werden, um den Schalldämpfer gründlich zu reinigen. Sowie im Anschluss in einem Ultraschallbad zu waschen.

  • Düse oben, konisches Design um alle Bereiche zu erreichen

  • Sauger unten

  • Modul des SD in die Mitte (beidseitig nutzbar) 

  • Rillen in der Seite um einen Luftstorm zugewährleisten und Strahlgut zu entfernen

Zum Entfernen von Pulverrückständen und Verkokungen in den Modulen des Schalldämpfers

Funktioniert mit: 

  • Modul normal

  • Abschlussmodul Front

  • Abschlussmodul Mitte

  • Doppelmodul "Verbinder"

Einzelne Module im Anschluss in je einen Modulhalter klemmen für ein Ultraschallbad 

PLA 50% ist ausreichend

Set 1: Module

Set 2: Schalldämpferkörper (Gewinde)

Ausschließlich sauberes Wallnusstrahlgut verwenden 0,4mm!

With the cleaning aid, a walnut blasting device (e.g., Autool HTS558) can be used to thoroughly clean the silencer. Then wash in an ultrasonic bath.

  • Nozzle at the top, conical design to reach all areas

  • Suction cup at the bottom

  • SD module in the middle (can be used on both sides)

  • Grooves on the side to ensure air flow and remove blasting material

For removing powder residues and coking in the modules of the silencer

Works with:

  • Normal module

  • Front end module

  • Center end module

  • Double “connector” module

Clamp individual modules into a module holder for an ultrasonic bath

PLA 50% is sufficient

Use only clean walnut blasting material 0.4 mm!