1 / 1
Double 608 Bearing Guide Pulley for Winch / Hoist — zdjęcie 1

Double 608 Bearing Guide Pulley for Winch / Hoist

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a heavy-duty, wide-profile pulley wheel designed to guide ropes or thick cords seamlessly

Ocena
0 / 5
Polubienia
3
Pobrania
8
Wydruki
0
Wyświetlenia
100
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

When building winches, lifting mechanisms, or high-speed launch rails, a single bearing can sometimes tilt under the tension of the rope. I designed this much wider pulley to accept two 608 bearings, distributing the load evenly across an 8mm axle. The deep V-groove profile ensures that your paracord, rope, or cable stays securely tracked in the center without slipping off the edges.

Features

  • Dual Bearing Core: Press-fit slots for two 608 bearings for maximum smoothness and stability.

  • Wide Deep Groove: Safely accommodates thicker ropes and prevents derailment during operation.

  • Heavy Load Ready: Ideal for linear motion systems, heavy lifting, or high-tension cord mechanisms.

Hardware Required

  • 2x 608 Bearings: (8mm ID x 22mm OD x 7mm Width).

  • 1x 8mm Axle: An M8 bolt, a piece of 8mm smooth rod, or a sturdy 3D printed pin.


Print Settings

This was designed to print easily with standard settings, though a few extra walls will help with the press-fit strength.

  • Layer Height: 0.20 mm

  • Infill: 15-20% (Gyroid or Grid)

  • Wall/Perimeter Count: 3 to 4 walls (Highly recommended to ensure the bearing socket doesn't split when pressing them in).

  • Supports: No supports required if printed flat on its side.

  • Material: PLA, PETG, or ABS.

Assembly Note The bearing tolerances are designed for a tight press fit. Lay the pulley flat on a table, align the bearing, and press firmly and evenly. Repeat on the other side.

Tagi