5/8 PVC Tee Connector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 5/8ths of an inch "PVC Tee Connector". It is not recommended to print in PLA since it will snap.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 178
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
This is a simple 5/8" Tee made to join two pieces of 5/8" PVC together.
It’s meant for 5/8" outer diameter PVC (0.625"). The fit should be snug enough to hold well, but still slide on without needing to fight it (depending on your printer tolerances).
Good for:
DIY frames
Hobby builds
Prototypes
Random projects where you just need a clean T joint
The body is thickened a bit around the center so it doesn’t crack at the joint, since that’s usually the weak point. Overall it’s just a solid, simple connector that does exactly what it’s supposed to do. If you are printing with PLA or PETG, please message me for a thickened model.
If you need a model in-between the small and medium or in-between the medium and large, please message me and give me measurements.
ABS is recommended for this print.