5/8 PVC Tee Connector
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 5/8ths of an inch "PVC Tee Connector". It is not recommended to print in PLA since it will snap.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 31
- Makes
- 0
- Views
- 178
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
This is a simple 5/8" Tee made to join two pieces of 5/8" PVC together.
It’s meant for 5/8" outer diameter PVC (0.625"). The fit should be snug enough to hold well, but still slide on without needing to fight it (depending on your printer tolerances).
Good for:
DIY frames
Hobby builds
Prototypes
Random projects where you just need a clean T joint
The body is thickened a bit around the center so it doesn’t crack at the joint, since that’s usually the weak point. Overall it’s just a solid, simple connector that does exactly what it’s supposed to do. If you are printing with PLA or PETG, please message me for a thickened model.
If you need a model in-between the small and medium or in-between the medium and large, please message me and give me measurements.
ABS is recommended for this print.