Christmas Tree Long Funnel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a funnel end that is intended to fit over 3/4" SharkBite brand PEX to make an inexpensive Christmas tree…
- Ocena
- 5 / 5
- Polubienia
- 8
- Pobrania
- 44
- Wydruki
- 1
- Wyświetlenia
- 519
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
This is a funnel end that is intended to fit over 3/4" SharkBite brand PEX to make an inexpensive Christmas tree watering funnel. There are small channels in the end that allow air to escape preventing a column of air from forming in the pipe and preventing water flow down. No glue was needed to attach it to the pipe successfully.
A 5-foot section of PEX can be purchased at Lowes for about $2.50 at the time I'm writing this (12/22/2018) and filament+electricity cost was approximately $3.50.
Print Settings
Printer:
Folgertech 2020i3
Rafts:
No
Supports:
No
Resolution:
0.2mm layers, 0.4mm nozzel
Infill:
30% 3D honeycomb
Filament:
Hatchbox ABS
Black
Notes:
Printed with 4 walls to make sure the final product is water tight.
Category: Decor