Christmas Tree Long Funnel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a funnel end that is intended to fit over 3/4" SharkBite brand PEX to make an inexpensive Christmas tree…
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 44
- Makes
- 1
- Views
- 519
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
This is a funnel end that is intended to fit over 3/4" SharkBite brand PEX to make an inexpensive Christmas tree watering funnel. There are small channels in the end that allow air to escape preventing a column of air from forming in the pipe and preventing water flow down. No glue was needed to attach it to the pipe successfully.
A 5-foot section of PEX can be purchased at Lowes for about $2.50 at the time I'm writing this (12/22/2018) and filament+electricity cost was approximately $3.50.
Print Settings
Printer:
Folgertech 2020i3
Rafts:
No
Supports:
No
Resolution:
0.2mm layers, 0.4mm nozzel
Infill:
30% 3D honeycomb
Filament:
Hatchbox ABS
Black
Notes:
Printed with 4 walls to make sure the final product is water tight.
Category: Decor