Xiegu G90 DE19 Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bracket to mount a DE19 interface to the top rear of a Xiegu G90
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 107
- Wydruki
- 0
- Wyświetlenia
- 356
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This bracket allows you to mount a DE19 interface to the top rear of a Xiegu G90. You will have to replace 4 of the original M3 screws with M3x8 screws. You'll need to print two brackets one will need to be mirrored in your slicer.
I replaced the included aux/trs cable with a shorter 1ft/30cm one. It's still a little long so I looped it around the fan bracket to take up some slack.
The corner radius on the DE19 isn't the same on all 4 corners, but this model uses the more conservative radius so you can mount the DE19 in either direction.
This was my first model made with FreeCAD. I'll post the FreeCAD file if anyone wants it, but be warned it's a disaster.
73