Scrub/Wiper for 250mm Voron Trident

I know that there are a lot of wiper / purge buckets out there for Vorons but I struggled to find anything that would work with my combination of 4WD Monolith belts that run across the front on the XY beam and a Beacon Probe that overhangs the rear of the toolhead. 

This main arm attaches to the Rear H extrusion, so it doesn't foul the forward-facing Monolith belts using 2 x 12mm M5 - Socket Cap Head Screws into Roll-in Spring T-Nuts

The wiper / scruber mount attaches to the main arm using 2 x M3 8mm fitting up into two M3 heat set inserts in the underside of the mount.

To make sure that you don't short out anything on the Beacon probe, the wiper mount uses a "Heatbed Nozzle Wiper" from the Bambu A1 printer.

The Bucket is fixed to the main arm using 8 Pairs of 6mm x 3mm magnets.  The bucket will only fit correctly one way around - the version number to the front.  This amount of magnets is probably over the top, but this is a very common and therefore relatively low-cost magnet, so I wanted to make sure that it had a good attachment.  I had to use magnets to allow the bucket to fix from the underside of the main arm, so nothing interfered with the beacon probe.  The wings on the bucket are also designed not to foul the toolhead.

BOM

• 2 x 12mm M5 - Socket Cap Head Screws

• 2 X M5 Roll-in Spring T-Nuts

• 2 x 8mm M3 - Socket Cap Head Screws

• 2 x M3 Heat Set Inserts (M3x5x4)

• A1 Nozzle Wiper

• 16 x 6x3mm neodymium magnets

I have printed all the parts using Polymaker PolyLite ASA Grey using the Voron Parts print profile.