Corne Cherry V4 Case Bottom 6 deg incline
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an addition to the model created by @alko. This adds the inclined bottom for the Cherry-style board.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 88
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This is an addition to the model created by @alko (https://www.printables.com/model/1297216-corne-choccherry-v4-case). This adds the inclined bottom for the Cherry-style board, since the original model only contained an inclined bottom of 6 degrees for the Choc-style board. This is the same 6-degree inclined bottom, but for the Cherry-style board.
Materials used for assembly:
8x threaded insert (M2.5x4x3.5)
8x bolt with flat head (M2.5x8 → M2.5x10 is recommended though)
8x 8mm rubber bump pads to prevent sliding
Printed using PETG at 15% infill at normal quality settings, though PLA or other materials should work fine as well. Printing at a higher infill presumably makes the keyboard quieter, but I haven't tested this.