RC Wheel Loader Front Spotlights
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Front spotlight arms for 3mm LEDs
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 527
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Front spotlight arms for 3mm LEDs with holders. There is no need to reprint the front chassis, just pass the wires into the hole above the fender, line up the arm and drill a small 2mm hole, the bottom arm has an indentation that goes into the hole and prevent the arm from turning and also hides the wires. Print the arms face up with supports on plate only.
The resistor for the leds need to be desoldered so that the wires go through the arm, just peel the shrink at the led side and desolder, now if you want to keep the stock brightness (witch is too low for my taste) just flip the wire around so that the resistor is at the other end and solder back. If you like higher brightness i found that using a 10ohm resistor for both the leds will bring it to about 3v and it will be really bright.
Still waiting on parts so my model is not finished yet
P.S. if PofessorBoots reads this, for future models and PCBs, please give the lights more voltage oh and more lights on the models :D Thanks