Stark Varg Stand Charger Rubber Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stark Varg Stand Charger Rubber Feet
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- GNU General Public License v2.0
Stark Varg Stand Charger Rubber Feet
I attached these rubber feet to the charger because the stand kept slipping when I lifted the motorcycle onto it (at least on smooth surfaces and carpet).
I printed the part four times using (BBL) TPU 95A on a Snapmaker U1.
I used 4 walls, 5 top and 5 bottom layers, with a layer height of 0.20 mm.
Perhaps my filament was too old, but with the default profile, the extrusion couldn't keep up, so I reduced the volumetric speed to 5 mm³/s (I think the default was around 12.5 on the TPU filament).
The print was then painfully sloooow, but the quality was perfect.
In Switzerland, we have double-sided adhesive tape that's 50 mm wide.
The parts fit on it widthwise, so if you use this tapes, then you only need to cut the adhesive tape to the correct length.
In countries with inch-based (if they have 2-inch wide tapes), you can enlarge the model by a few percent in that direction (on "X" or "Y" size + 2-3%?).
It can also be attached with contact adhesive.
Before attaching it, it's best to clean the charger's feet with lighter fluid or brake cleaner (for better adhesion).
The model is available for free download and use.
If you'd like to buy me a coffee for my effort, you can do so via: