Drybox Spool Roller - suits Sistema Square 3.5L
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A drybox spool roller designed for the Sistema Square 3.5l box.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 48
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
I have been using the Sistema Klip It Plus 3.5l boxes for spool storage, and am starting to convert them to dryboxes. This is a system that allows easy filament spool swaps from the large top lid without requiring an exact fit to the box side. The roller is easily removed and replaced, and the end supports provide plenty of range in case the lid fit is not exact.
I've also included 2x feet to allow the box to stand on its side and roll effectively. These can be swapped for any other vertical stand or mount solution.
Instructions:
Print 2x spool roller collars, 2x spool mounts, and 1x spool roller
Press fit the 608 bearings into the roller. They should be in slightly deeper than the flat face.
Fit the spool roller collars onto the roller, angled side in. This is a friction fit, and will require some force.
Mount the spool mounts directly opposite each other in the center of your box. You can use the mold marks for placement.
Place your filament spool inside, add the roller, and close the box. You're good to go!
Additional materials:
3M mounting tape
2x 608 bearings