Anker Zolo Skadis Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for the Anker Zolo wireless charging puck that lets you attach it to your IKEA Skadis board.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 71
- Wydruki
- 3
- Wyświetlenia
- 317
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I modified the MagSafe charging stand from Chongfun to make it work for the Anker Zolo Wireless charging puck. Print the holder and two hooks, attach the hooks into your Skadis board, and then slide the holder on. I left a hole in the bottom of the holder that was large enough to fit the USB-C cable through, so make sure you feed the cable through to get a nice flush finish. I was able to get my charger to just press fit into the housing, and haven't had much issue with it so far. It works well with my Pixel 6 with a magsafe case on it.
I printed mine in Sunlu Pla+2.0. Mine gets a little warm when charging, so I expect the fit to loosen over time. Might reprint in PETG for longevity.