FZ-M1 Back Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clean, flush back cover for Panasonic FZ-M1 when removing or replacing the barcode scanner module.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 99
- Wydruki
- 0
- Wyświetlenia
- 244
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3D-printable flush back cover for the Panasonic FZ-M1, designed to replace the factory barcode reader module with a clean, low-profile panel. Perfect if your unit never had the scanner, the module was removed, or you just want a sleeker, snag-free back.
The cover matches the device’s contour and sits flush with the rear housing, keeping the tablet looking finished while protecting the internal opening from dust and debris.
Features:
Clean, flush-fit replacement for the barcode scanner opening
Restores a smooth back profile
Simple drop-in replacement (no electronics required)
Ideal for FZ-M1 units without a scanner or with a removed/damaged module
Uses existing screws
Printing notes (suggested):
Print in PETG or ABS for better heat and impact resistance (PLA works for light use)
No supports needed (depending on your orientation)
Infill (60–80%)
May need trimming/sanding depending on version on FZ-M1.