Tapo C200C Wall Mount

A minimalist, functional wall mount specifically designed for the Tapo C200C.

Important Note on Compatibility: This model is designed specifically for the C200C variant, which features bottom mounting holes designed to slide onto screw heads. It is not compatible with the standard C200 unless you have the twist-lock adapter.

Print Settings

To ensure the bracket is strong enough to support the camera weight over time, I recommend the following:

• Material: PETG (Recommended for better durability and slight flexibility).

• Wall Loops: 4 (Crucial for structural integrity).

• Infill: 15% Gyroid.

• Support: Not required if oriented correctly.

Installation & Assembly

• Mounting the Camera: Because this design is low-profile, there isn't extra clearance for standard screw heads to sit "inside" the plastic. You will need to slice the top off the screws (using a Dremel or similar tool) after they are driven into the mount, or use very short screws! 

• Hole Spacing Update: The original design had a 30mm spacing which was a very tight fit. This uploaded version (V2) has been updated to 31.5mm spacing for a smoother fit.

  • Note: I am currently using my 30mm prototype; the 31.5mm version is calculated to be the "correct" fit but remains untested by me personally. Feedback is welcome!

Disclaimer

Please ensure your wall fixings are secure. I am not responsible for any damage to your camera resulting from improper installation or print failure.