Encaustic Painting Hot Plate Brush Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This holder allows you to keep your encaustic brushes in contact with the hot plate so the wax stays molten.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Obviously you'll need to print two end pieces. No supports are needed and a 15% infill seemed okay. I used PETG due to the proximity to the heat plate, but as long as you don't get it too close, I suspect PLA should be fine. As you can see from the photo, the plastic frames are several inches from the hot plate.
A 3/8 inch metal rod should press fit in the openings. If it's a little loose, you can use some glue. If it's a little tight, warm up the rod and melt it in. Your local hardware store should have lots of options for metal rods. I used brass, but aluminum, steel, or even a threaded rod could work.
If you want to use a different diameter rod or height, you can edit the OpenScad file easily. As long as you don't deviate too much from the original settings, you should be able to change the parameters at the start of the file.