Encaustic Painting Hot Plate Brush Holder
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€1.54 – €1.88 net (excluding VAT)
For file: encausitc-brush-rest_0.4n_0.2mm_PETG_COREONE_1h10m.bgcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.71 excluding VAT (range midpoint).
- Weight reported by the author
- 35 g
- Print time reported by the author
- 1.17 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This holder allows you to keep your encaustic brushes in contact with the hot plate so the wax stays molten.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 116
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Share Alike
Obviously you'll need to print two end pieces. No supports are needed and a 15% infill seemed okay. I used PETG due to the proximity to the heat plate, but as long as you don't get it too close, I suspect PLA should be fine. As you can see from the photo, the plastic frames are several inches from the hot plate.
A 3/8 inch metal rod should press fit in the openings. If it's a little loose, you can use some glue. If it's a little tight, warm up the rod and melt it in. Your local hardware store should have lots of options for metal rods. I used brass, but aluminum, steel, or even a threaded rod could work.
If you want to use a different diameter rod or height, you can edit the OpenScad file easily. As long as you don't deviate too much from the original settings, you should be able to change the parameters at the start of the file.