Inlays for the Kistenberg NORS14 (v2 - now with label area)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Full rework of my previous models. Added an area for 9mm labels and some new inlays.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 29
- Wydruki
- 1
- Wyświetlenia
- 179
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
About
This project is the successor to my older project. I've redesigned all models from scratch, adjusted tolerances and added a label area for printed labels of up to 9mm height.
What's new?
There a new inlays with a two-cell width for e.g. resistors and new inlays that fit the corner pockets of the NORS14.
I dropped the quarter-split inlays as there is no (good) area to add a label to them.
Print Instructions
pretty straight forward - no support needed.
For the 3-part-inlays: the "..Middle-or-Top" part needs to printed two times.
Note
If you're missing a variation of any of the new models, drop me a comment and I'll see what I can do.