Inlays for the Kistenberg NORS14 (v2 - now with label area)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Full rework of my previous models. Added an area for 9mm labels and some new inlays.
- Rating
- 5 / 5
- Likes
- 11
- Downloads
- 30
- Makes
- 1
- Views
- 181
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
About
This project is the successor to my older project. I've redesigned all models from scratch, adjusted tolerances and added a label area for printed labels of up to 9mm height.
What's new?
There a new inlays with a two-cell width for e.g. resistors and new inlays that fit the corner pockets of the NORS14.
I dropped the quarter-split inlays as there is no (good) area to add a label to them.
Print Instructions
pretty straight forward - no support needed.
For the 3-part-inlays: the "..Middle-or-Top" part needs to printed two times.
Note
If you're missing a variation of any of the new models, drop me a comment and I'll see what I can do.