Ikea Maximera drawer side glass bracket
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is replacement part for Ikea Maximera drawer bracket which helps to hold optional side glass panels.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 146
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Open Community License v1
Replacement part for Ikea Maximera drawers. These parts are usually delivered with drawer and are used as cover and as bracket if side glass panel are mounted. Ikea respective part numbers corresponding to the models are in table below.
There are two sizes/heights of Maximera drawers - medium and high. Length or width of drawer doest not matter for this specific part.
For Medium size drawer, two Glass_bracket_drawer_medium are required. Brackets will snap in place.
For High size drawer two Glass_bracket_drawer_high and two Glass_bracket_pin are requred. Bracket is snap in place first, then secured by pushing pin to factory pre-drilled hole.
Part/model | Ikea part number |
|---|---|
Glass_bracket_drawer_medium | 128536 |
Glass_bracket_drawer_high | 128537 |
Glass_bracket_pin | 128539 |
Print settings
Brackets are recommended to be printed standing:
Brim optional
4 perimeters
0 % infill
no supports
Pin is printed laying on one side to not need any support. Please check correct orientation, pin is not symetrical - one side is flat:
4 perimeters
100 % infill
no supports
Pin is sensitive to size accuracy to correctly fit into factory pre-drilled hole. It is recommended to print one sample first for test and adjust size slightly if necessary.
Updates
26.02.2026
Initial release of Glass_bracket_drawer_medium, Glass_bracket_drawer_high, Glass_bracket_pin models