Core One Filament compartment door
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Door to close off the filament compartment
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 477
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is my solution for a door to close off the filament compartment. Existing holes are used to attach it to the Core One housing. The door is held closed by magnetic tape (12.5 x 1.5 mm). The window is made of 4mm Plexiglas (300 x 300mm), but 3mm would also be sufficient. The original spool holder can still be used. After experiencing a little warping with the first few prints, I added adhesive surfaces to the ends of the models.
Three M3 x 12 screws are required to attach it to the housing, and two M3 x 25 screws are required for the handle. you can use a piece of filament for the hinge axis or 2mm wire.