Core One Filament compartment door
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Door to close off the filament compartment
- Rating
- 5 / 5
- Likes
- 21
- Downloads
- 45
- Makes
- 0
- Views
- 477
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
This is my solution for a door to close off the filament compartment. Existing holes are used to attach it to the Core One housing. The door is held closed by magnetic tape (12.5 x 1.5 mm). The window is made of 4mm Plexiglas (300 x 300mm), but 3mm would also be sufficient. The original spool holder can still be used. After experiencing a little warping with the first few prints, I added adhesive surfaces to the ends of the models.
Three M3 x 12 screws are required to attach it to the housing, and two M3 x 25 screws are required for the handle. you can use a piece of filament for the hinge axis or 2mm wire.