Adjustable Mount for the Waveshare OV5640 Camera PCB
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adjustable mount for the Waveshare OV5640 5MP camera PCB
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a camera for my Voron Trident that would fit to the underside of the front rail due to the lighting (Disco on a Stick) being fitted to the inside of the top rail and not hit the toolhead.
I wanted to make the camera adjustable so that it can be set to the optimal angle when fitted. I opted for a cylindrical mount and holder, which does make printing a bit more of a challenge, but I have found the orientation shown in the image attached that gets the best results for me - I used "organic tree supports".
Due to the cylindrical design, the design is built from three pieces and then assembled during installation. The cable socket needs to be pushed through the end mount and attached to the PCB before screwing the M2 screw through the PCB into the mount.
Camera used UK link PI Hut - Waveshare 5MP OV5640 Auto-Focus USB Camera Board
BOM
1 x M4 6mmx6mm Heat Insert
1 x M4 x 16mm Full Thread Cap Head Screws
2 x M4 x 12mm Washer (typically 0.9-1mm thick)
3 x M2 3.5mmx4mm Heat Insert
3 x M2 x 6mm Full Thread Cap Head Screws
I have printed all the parts using Polymaker PolyLite ASA using the Voron Parts print profile.